|
05 June 2016, 15:27
|
#1 |
|
Registered User
Join Date: Jan 2002
Location: Germany
Posts: 7,002
|
A2065/SLIRP crashes with JIT
WinUAE crashes as soon as the network is accessed if JIT is enabled. It crashes without dump, just the usual "program does not work any more" message.
Without JIT it boots normally and can access the network. If I enable JIT later, it does not crash but any network access does not return (waits infinitely). In 3.2.1 it did not crash but did not get a response from DHCP, either. |
|
|
05 June 2016, 15:35
|
#2 |
|
WinUAE developer
Join Date: Aug 2001
Location: Hämeenlinna/Finland
Age: 49
Posts: 26,523
|
I can't duplicate any crashes but A2065 has problems with "new" JIT: http://eab.abime.net/showthread.php?t=80770
EDIT: Appears to be 64-bit only. Probably same hidden problem in both 32-bit and 64-bit. Last edited by Toni Wilen; 05 June 2016 at 15:49. |
|
|
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | |
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| WinUAE crashes if A2065 cable disconnected | thomas | support.WinUAE | 1 | 26 May 2015 15:39 |
| SANA2 (uaenet.device) / SLIRP / A2065 (was: WinUAE SANA driver usable?) | amigafreak68k | support.FS-UAE | 53 | 14 October 2014 21:25 |
| slirp network emulation backend | Toni Wilen | support.WinUAE | 27 | 28 February 2014 13:48 |
| SLiRP (user mode nat) | neozeed | request.UAE Wishlist | 9 | 21 June 2013 16:38 |
| WinUAE crashes when switching from MMU to JIT | jotd | support.WinUAE | 1 | 19 November 2010 21:34 |
|
|
