Screenmodes with WinUAE 2.3.3

I've managed to get my old 1200 HD imaged as a hardfile and running in WinUAE 2.3.3. My question is, is there any way to get the screenmodes into a higher resolution? I've tried setting it to super high-res but its like the window is hardwired not to show more that 700ish pixels wide.

any suggestions?

[Arnie]

Have you tried installing Picasso96?

It's available from Aminet.

[LocalH]

You also need to make sure that WinUAE is set to SuperHires resolution on the Display tab, if you're going to use the native chipset SuperHires mode (and also ensure that your window or fullscreen resolution is set to at least 1280 pixels wide, plus any overscan if you have Workbench set to utilize it). You'll also need to use the filters control panel to make the height proportional to the width as compared to a physical Amiga. You can either use Normal line mode and a 4x vertical filter, or you can use Double line mode and a 2x vertical filter (I recommend the latter, the image will be sharper as Double line mode is nearest-neighbor, while the filters are generally interpolated).

I can't remember if WinUAE needs SuperHires to properly display any of the other advanced native modes (like Productivity, Euro36/72, Super 72) as it's been a while since I've done anything significant in WinUAE.

[Amiga1992]

Talking about this, I have a hard time now with WinUAE displaying a full screen image on the right proportion of scaling. I need to use teh filters? This is new to me, I never used filters before, the picture would never get distorted when I hit fullscreen, I would get a border, but now the screen is covered.