|
23 May 2011, 18:32
|
#1 |
|
Registered Whdload user
Join Date: Oct 2006
Location: Finland
Age: 48
Posts: 532
|
Right setting for mask in HDtoolbox with 64MB ram
I tried my new pfs3-formatted cf in my A1200 and immediately got an error "allocated memory does not match mask". I have a 1230IV with 64MB, so what should my mask setting be
 Could not find any "table" for calculating the mask setting  |
|
|
23 May 2011, 19:22
|
#2 |
|
-
Join Date: Jul 2003
Location: Helsinki / Finland
Age: 43
Posts: 9,863
|
What is your mask setting now? Is the CF connected to your internal IDE or perhaps a SCSI kit?
There is a chapter on mask in the pfs3 manual. |
|
|
|
23 May 2011, 19:45
|
#3 |
|
Registered Whdload user
Join Date: Oct 2006
Location: Finland
Age: 48
Posts: 532
|
Damn, you're right Jope. I had some weirdness rrying to read the guide-files with some winguide app. Some pages were total garbage and the linking was kinda borked. After some serious digging I finally found the page you referred to
 Now everything is ok . Thank you
|
|
|
|
23 May 2011, 20:24
|
#4 |
|
-
Join Date: Jul 2003
Location: Helsinki / Finland
Age: 43
Posts: 9,863
|
So 0xfffffffc did the trick then?
|
|
|
|
23 May 2011, 21:13
|
#5 |
|
Registered Whdload user
Join Date: Oct 2006
Location: Finland
Age: 48
Posts: 532
|
Yes it did
|
|
|
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | |
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| FS: Phase 5 Blizzard 1230 IV + 64MB Ram | Jon Hare | MarketPlace | 0 | 03 April 2012 12:48 |
| Mask setting problem (PFS3 & A2000/Derringer030+GVP2000HC+8) | amigoun | support.Other | 0 | 22 March 2012 11:19 |
| FS: Blizzard 1260 060@72MHz + 64MB RAM | stachu100 | MarketPlace | 0 | 24 November 2010 13:16 |
| FS: For Sale MBX1230XA @ 50mhz + 64mb ram | peyo64 | MarketPlace | 2 | 16 June 2010 23:32 |
| For Sale: Blizzard 1260 060@80MHz 64MB RAM or 060@106MHz and 0MB RAM; it's not a joke | stachu100 | MarketPlace | 5 | 16 May 2010 10:43 |
|
|
