25 May 2022, 14:18 | #1 |
Registered User
Join Date: May 2022
Location: Aberdeen
Posts: 4
|
X1 Oscillator & shorting?
i have a dead a500 rev6a board.
the X1 OSC has been hacked out looks like board has been damaged put new one in no joy when testing continuity it appears 3 of the pins are connected? 1 4 2 3 (looking from top of board 1,2 and 4 all appear to be ground (buzzes out continuity) i think 4 should be 5V ? Pin 3 in output of the 28.xxx pulse? any advice/thoughts? am i right with the pinout? etc shorting coming from board damage underneath? |
25 May 2022, 14:23 | #2 |
Registered User
Join Date: May 2022
Location: Aberdeen
Posts: 4
|
|
28 May 2022, 16:29 | #3 |
Registered User
Join Date: Jun 2012
Location: Toronto / Canada
Posts: 232
|
Pins 1 & 2 are ground, Pin 4 is VCC +5V and Pin 3 is 28.x MHz Frequency.
Shaf |
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
Thread Tools | |
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Warp Engine oscillator | desantii | support.Hardware | 9 | 07 May 2021 19:48 |
More power for usb mouse adapter via shorting a resistor? | wairnair | support.Hardware | 4 | 22 October 2019 13:03 |
Duff Oscillator? | BarryB | support.Hardware | 13 | 05 November 2014 22:15 |
XPert Merlin Oscillator | gwionm | support.Hardware | 5 | 14 October 2008 01:16 |
where can i get an 80mhz oscillator | DoogUK | support.Hardware | 2 | 08 April 2008 15:35 |
|
|