15 November 2010, 13:04 | #1 |
Registered User
Join Date: Jun 2010
Location: FRANCE
Posts: 222
|
Picture of SX-1 MB Rev.2.0 (back side)
Hi,
I have a defective SX-1 here and another one working. The two sx1 are Rev 2.0 but on the working one, there are some components soldered on the backside. The defective one has no component on backside... It would be very helpfull if someone could send me a picture of his/her Rev.2.0 SX1 (back side of the "motherboard"). Thanks in advance. Just in case of, here are the problems : 1) In "test mode" (jumper 3 closed), the board is shown as working in the early startup but it cannot boot on an external floppydrive... the drive is making a sound during 1/4 seconds but it does not start reading the floppy. 2) Every time I put Ram in it (the same RAM module I have in the other one working and with exactly the same jumper configuration), I have flashing lights and no boot/no early start-up.... No life Thanks in advance for your help ! |
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
Thread Tools | |
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Differences between A2630 rev 9 to and rev 9.2 | 8bitbubsy | support.Hardware | 0 | 21 May 2013 16:58 |
Board Revision ADVICE Rev 1D.1 vs Rev 2B | W4r3DeV1L | support.Other | 1 | 02 December 2008 23:44 |
Ok ---Im ready to be transported back.back.back to the 90s. Check out what Ive got. | nc88keyz | Amiga scene | 9 | 12 January 2008 22:58 |
has anyone dislodged CIAs from a rev 6a?? possible defect on rev 6a?? | NfernalNfluence | support.Hardware | 3 | 27 August 2007 10:27 |
HELP ! A600 Rev 2B mainboard picture | trash44fr | Amiga scene | 4 | 14 July 2003 14:04 |
|
|