English Amiga Board


Go Back   English Amiga Board > Support > support.Hardware

 
 
Thread Tools
Old 11 February 2015, 23:36   #1
amigo-mexicano
Amiga's Power!

amigo-mexicano's Avatar
 
Join Date: Mar 2014
Location: Mexico City
Posts: 54
Exclamation Help with A500+ does not boot, white screen, blinking power led

Hi, I have a cool A500+ for repair, when receiving it, was going guru all the time, no matter what I loaded. It stays OK on boot screen for hours.

It had a previous repair of battery leak.

After inspecting a little, saw some green goo near U12 and C12, so I removed them and cleaned all, tested continuity etc.., but when putting everything back, now I get a white screen and the power led blinks, no boot anymore.

I tested Gary chip on other miggy and works OK. I replaced U12 and C12, and problem is the same.

Any ideas on what to try next?

Thanks!
amigo-mexicano is offline  
Old 12 February 2015, 00:16   #2
Zippy Zapp
Registered User

Zippy Zapp's Avatar
 
Join Date: Sep 2013
Location: CA/USA
Posts: 344
Hi.

Is there anything plugged into the trap door expansion?

I had one that was white screen and if I remember correctly the rom chip needed to be reseated. You might check the chips to make sure they are all seated properly.

I think you may want to try unplugging keyboard make sure it is not bad, seems I remember a problem there too on my old one. This was 20 years ago, though...
Zippy Zapp is offline  
Old 12 February 2015, 00:19   #3
amigo-mexicano
Amiga's Power!

amigo-mexicano's Avatar
 
Join Date: Mar 2014
Location: Mexico City
Posts: 54
Hi!

Nothing connected on the trap door.

I tested with and without keyboard, in fact with the bare motherboard, and white screen all the same.

I will re-check all other chips, just to be sure.

Thanks!
amigo-mexicano is offline  
Old 12 February 2015, 15:14   #4
Viserion
Registered User
 
Join Date: Mar 2013
Location: Oslo/Norway
Posts: 263
Have you looked at the resistors?

I had a burned resistor at R309 that caused white screen. After I replaced it,it booted up, although it still not as stable as it should be.
Viserion is offline  
Old 13 February 2015, 01:36   #5
Yulquen74
Registered User
 
Join Date: May 2013
Location: Kleppe / Norway
Posts: 217
have you checked the gary socket? if the legs of the gary chip have turned green, they should be cleaned with a nylon brush or similar.

also, since you replaced some parts, are you 100% sure you did not break any traces/vias in the process? I woud check all traces going to/from the "green" area.

sometimes even vias occasionally fail due to coorrosion damage.
Yulquen74 is offline  
Old 13 February 2015, 09:15   #6
rikbliz
Registered User
 
Join Date: Aug 2012
Location: Trenton, Ohio
Posts: 113
(deleted)

Last edited by rikbliz; 06 July 2018 at 09:16.
rikbliz is offline  
 


Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)
 
Thread Tools

Similar Threads
Thread Thread Starter Forum Replies Last Post
White screen at Amiga 500 power on? Saltaren New to Emulation or Amiga scene 16 14 February 2017 10:28
A500 White Screen xArtx support.Hardware 10 28 January 2015 06:46
A600 fuzzy white screen on boot! PowerPie5000 support.Hardware 4 21 January 2010 04:37
a1200 yellow screen and many times blinking LED Dmitry.mry support.Hardware 18 19 November 2009 12:54
blinking power led/no screen on amiga 500 Akuma support.Hardware 10 26 August 2006 13:45

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT +2. The time now is 00:46.


Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2021, vBulletin Solutions Inc.
Page generated in 0.09896 seconds with 15 queries