11 June 2021, 20:01 | #1 |
Registered User
Join Date: Dec 2020
Location: Philippines
Posts: 45
|
How to Read Digital Pin 5 and Pin 9?
Hi, there are some things I'm confused about how to read Pin 5 and Pin 9.
In HRM p.241 it says: "A button is a normally open switch that shorts to ground. The Amiga must provide a pull-up resistance on the sense pin. To do this, set the proper pin to output, and drive the line high (set both OUT ... and DAT ... to 1). Reading POTINP will produce a 0 if the button is pressed, a 1 if it is not." What I'm confused about this is if I should only do the writing of POTGO register once(set OUT and DAT to 1 at startup and only read DAT every frame) or should I do it for every frame(read DAT then set DAT to 1). Does the Amiga/controller automatically set the DAT to 1 if button is not pressed? And would this method don't cause any problems for controllers like Megadrive and CD32 even if I read Pin 5? Would Pin 9 read still work? |
13 June 2021, 01:14 | #2 |
Registered User
Join Date: Sep 2017
Location: Kansas, USA
Posts: 328
|
Write once to POTGO. The built-in pull-up resistor will apply +5v to the pin. When you read POTINP (POTGOR in newer HRM) the relevant data bit will be 0 if that pin is currently grounded via a button, or 1 if not, that's all there is to it.
No idea about Megadrive or CD32 pads. |
13 June 2021, 15:50 | #3 | |
Registered User
Join Date: Dec 2020
Location: Philippines
Posts: 45
|
Quote:
Regarding the Megadrive and CD32 I look at the pinouts here: http://wiki.icomp.de/wiki/DE-9_Joystick With Megadrive, since I write to Pin5(Button3), it will apply +5v which on the Megadrive side Pin5 is +5v. I assume nothing bad will happen here and the controller will work as a 2 button controller because of Pin 7(+5v) of Amiga sending high signal to Pin7(Select out) of Megadrive? For CD32, again Pin5(Button3) is set and high signal is send on the Pin5(Shift Load Out) of the CD32 controller. When shift load is high, CD32 will treat the controller as gamepad mode(2 buttons only). So I guess nothing bad will also happen here? I don't know anything about electronics... |
|
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
Thread Tools | |
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Normal 34-pin floppy drive on external 26-pin roctec | SilverZguru | Hardware mods | 45 | 20 December 2020 12:05 |
15-pin female plug (PC joystick) to 9-pin female plug (Amiga joystick port) | eva | support.Hardware | 7 | 21 April 2016 20:03 |
23-pin to 9-pin video cable pinout | MagerValp | support.Hardware | 9 | 22 August 2008 15:00 |
VGA Adapter 23 pin -> 15 pin High Density | @UAE | support.Hardware | 11 | 16 October 2006 13:32 |
Pin Out Help... | DeltaWolf7 | support.Hardware | 16 | 03 September 2002 11:16 |
|
|