uae-configuration joyport0 BUG

[Groundhog]

When you try to modify the joyport0 or joyport1 entries with uae-configuration from the emulated machine, they aren't updated until you hit F12.

Example :

1) start with "none" in joyport1
2) shell> uae-configuration joyport1 kbd2
3) you can still move the cursor with the arrow keys -> so no effect until now
4) hit F12, cancel
5) you can't move the cursor with the arrow keys -> joystick OK.

EDIT: Found out that there was the same prob with input.mouse_speed

[Groundhog]

I've tried to play with every possible record but when you try to modify an input device with the uae-configuration tool, it isn't updated until you hit F12.

Is there a special command to use to avoid this ?

[Toni Wilen]

joyportx and some input device commands will work in next beta but full input panel support may not so easy to do (without causing performance issues)

[Groundhog]

Great ! Thanks a lot.

BTW, I tried the new beta. While it's difficult to judge, the prob with the mouse delay seems to happen when VSync is off too now. Altough both seem to be to a lesser extent (again, difficult to judge).

Also, I don't know if you remember about the prob with "All Terrain Racing". While still present in the beta, I found out that started with VSync off, the problem don't appear anymore. Another game which don't seem to work properly when started with VSync ON is "Slam Tilt". Hope that'll be helpful.

[Toni Wilen]

Also, I don't know if you remember about the prob with "All Terrain Racing". While still present in the beta, I found out that started with VSync off, the problem don't appear anymore. Another game which don't seem to work properly when started with VSync ON is "Slam Tilt". Hope that'll be helpful.

Don't care. 68020+/AGA game (or WHDLoad + 68020+) not working = buggy game requiring specific timing.