|
03 April 2013, 23:15
|
#1 |
|
Registered User
Join Date: Apr 2009
Location: N/A
Posts: 962
|
Preventive care for my 1084S monitor
Hello, lately I am not switching my A500+ too much. However when I do switch it on I noticed that after a few minutes (not more then 10 minutes) my 1084S monitor for a few seconds shows the picture a little bit pink, then normal again and so on.
Obviously this must be a sign of trouble ahead. I was wondering, what might be the problem? is there anything I can do in order to prevent any damage? |
|
|
04 April 2013, 09:18
|
#2 |
|
Registered User
Join Date: Mar 2004
Location: finland
Posts: 1,838
|
Probably a solder joint giving up slowly - if not a cable/connector contact problem.
|
|
|
|
04 April 2013, 09:33
|
#3 |
|
Registered User
Join Date: Apr 2011
Location: birmingham
Age: 55
Posts: 2,827
|
it could be something simple like a loose wire in the monitor lead or a bad solder joint on the pcb of the monitor.
|
|
|
|
04 April 2013, 11:42
|
#4 |
|
Puttymoon inhabitant
Join Date: Mar 2007
Location: Tromaville
Age: 46
Posts: 7,544
  |
Agree, I had the same problem, checking and re-soldering RGB connector helped.
|
|
|
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | |
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Question about monitor 1084S-p1 | trydowave | support.Hardware | 15 | 06 July 2013 02:44 |
| C= 1084S monitor cable | carls | support.Hardware | 3 | 20 May 2013 16:54 |
| My New A500 and 1084s Monitor | Peter | Hardware pics | 3 | 17 February 2010 23:25 |
| 1084s monitor problem | aas5151 | support.Hardware | 1 | 03 July 2006 18:03 |
| 1084S monitor problem | Jan | support.Hardware | 17 | 13 May 2003 09:48 |
|
|
