Keep Active control panel "Line Mode" and "Interlaced Line Mode"

[Zilog]

Hi Tony,
ip possibile keep alive control panel "Line Mode" and "Interlaced Line Mode" when direct draw is active and Resolution Autoshich is on.

Thanks.
By.

[Toni Wilen]

You still haven't replied why do you need DirectDraw mode? It is mostly obsolete.

D3D mode should do everything (and more) unless you have ancient PC but then you should't use any special features to reduce slowdowns as much as possible.

[Zilog]

Originally Posted by Toni Wilen

You still haven't replied why do you need DirectDraw mode? It is mostly obsolete.

D3D mode should do everything (and more) unless you have ancient PC but then you should't use any special features to reduce slowdowns as much as possible.

...because the image is reality; i prefer see the image without filter and 3d correction.

[Toni Wilen]

Why do you think D3D can't be pixel perfect? You have config error somewhere, possibly even display driver control panel setting if you get blurry output in D3D mode. (also make sure filter mode is "no filtering", not "default")

[Zilog]

Originally Posted by Toni Wilen

Why do you think D3D can't be pixel perfect? You have config error somewhere, possibly even display driver control panel setting if you get blurry output in D3D mode. (also make sure filter mode is "no filtering", not "default")

Ok. I found my problem with d3d. The Problem was connect at the i used a Scanline Original + Scanline in Extra Setting Filter.

iI do a test; and the original scanline (in Menu Line mode) is more real; there is scanline when use resolution with 256pixel in Heigh and there isn't when use the resolution with 512pixel in Heigh; It possibile keep active the Menu Line mode when it set Resolution AutoSwitch On?

Very Thanks.