10 May 2022, 20:44 | #1 |
Registered User
Join Date: Sep 2016
Location: Michigan
Posts: 384
|
Fixing broken insertion pins
I obviously have nimble fingers or bad eyes but have damaged some insertion pins on reinserting a V2 vampire and the backside of the Rejuvenator board
(image attached) To fix I just took out the last two or three that were damaged and soldered the partial ones back in. Is this ok, do I need the whole row of pins to go in together to work right. They are now wired in some way side to side are they? |
10 May 2022, 21:31 | #2 | |
Banned
Join Date: Feb 2022
Location: Anywhere and everywhere I have a contract
Posts: 822
|
Quote:
Only way to know is put the parts back in to see |
|
10 May 2022, 22:25 | #3 |
Registered User
Join Date: Sep 2016
Location: Michigan
Posts: 384
|
Thanks
|
18 May 2022, 04:42 | #4 |
Registered User
Join Date: Dec 2015
Location: USA
Posts: 2,903
|
Hail and well met fellow Amiagician, hast though misplugged the accelerator perhaps skipping a pin in the process, mayhap? Or dost though just mean to say thy hands had crushed some pins, which tisn't evident in the fottergrafs?
|
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
Thread Tools | |
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Epoxy - fixing a broken pad | Sim085 | support.Hardware | 5 | 12 September 2019 20:19 |
Floppy disk insertion UI | Jope | support.FS-UAE | 9 | 23 June 2019 15:07 |
RetroManCave - Nice YouTube series on fixing a broken A500 | gimbal | Amiga scene | 19 | 07 October 2017 20:33 |
Need ideas on fixing A600 broken ide44 pin | kire_online | support.Hardware | 4 | 04 December 2011 22:28 |
4 way ide - broken pins | jimmer78 | support.Hardware | 16 | 05 May 2010 18:08 |
|
|