Amiga 600 Hard Drive

07 October 2001, 19:27

I want to buy a hard drive for my A600 and I have a few questions:

My A600 comes with Kickstart 37.300, will I have some problem with this?

Is it hard to open the amiga for plug the drive?

How many cost a 200-300 megs hard drive, more or less?

Thanks in advance

Amiga1992 · 07 October 2001, 21:54

Hey Uukrul!

37.300 is just fine, no need to get anything new. You will just have to get a hold of Workbench 2.05 or 2.1 for easier install.

It;s very easy to install it inside (plug and play

), however I dont know where you'll get the craddle to lie it in. My drive comes bolted to a metal craddle that lets it sit peacefully inside the miggy. If this came with your 600 I dont know, perhaps you open it up and the cradle is inside. If not, try to look for one, somewhere. It prolly is hard ;/ If I was you I would open the machine up and check it out (no warranties to void

), after unscrewing all the bolts be careful with the plastic holders on the side of the case, dont break them! You will have to push'em with something to open up the case.

I have no clues about prices, and I'd like to know because I want to expand my hard drive capacity as well

07 October 2001, 23:10

Many thanks Akira!!

I'll check tomorrow the inners of my A600

BTW, is this http://cgi.ebay.com/aw-cgi/eBayISAPI...tem=1281699842 the craddle you say?

Amiga1992 · 08 October 2001, 19:39

That's the thing! I suppose it would fit an A600 but I can't be 100% sure...

Mounting bracket, craddle, same thing, I had to make up a name for it

09 October 2001, 22:51

Well, I finally opened the A600 and the craddle was inside

, so no more worries about it.

I only need now the 1 meg memory expansion and the harddrive

Akira, the harddrive is only connected to the 44 pins connector on the left, isn't it?

BTW, did your monitor survive?. I found a doc in Aminet for connect an Amiga to a CPC monitor (soon I'll get a CPC 6128)

Salu2

kriz · 15 October 2001, 13:20

the problem is that only an 2.5" Hardrive will fit inside the small A600 case

(the same with an A1200) , But you can ofcourse use a standard 3.5" Hardrive but then it would end up hanging on the outside

(but it works

)..

getting a cheap 2.5" drive is problay the easiest

Amiga1992 · 15 October 2001, 18:29

Hey UUkrul

Yes, the hard drive is conencted to that thing only. both the IDE and power is transmitted thru it

I know a place storing 1MB Chip ram expansions for A600s, with clock and all. I will PM you with the location.

I havent taken my monitor to check yet

I dont have a CPC monitor BTW, I am connecting my 6128 to the 1084.

Cheers,

15 October 2001, 19:51

Last week on ebay I found two different memory expansions but the same guy won me

I can get it at Spain but I don't want to pay $40 for that memory. At least soon I'll put my hands on a cheap CPC 6128

Amiga1992 · 15 October 2001, 20:46

i paid 50 for my 6128, that is including shipping fropm the uk . of course without monitor :P

and i paid 30 dollars for my 1MB chip expansion.. i dont know if you could get it any cheaper than that ;/

15 October 2001, 20:59

Final price of the memory expansion was only 10 UK pounds but at this moment I'm out of money

((

07 October 2001, 19:27	#1
Uukrul Posts: n/a	Amiga 600 Hard Drive I want to buy a hard drive for my A600 and I have a few questions: My A600 comes with Kickstart 37.300, will I have some problem with this? Is it hard to open the amiga for plug the drive? How many cost a 200-300 megs hard drive, more or less? Thanks in advance

08 October 2001, 19:39	#4
Amiga1992 Registered User Join Date: May 2001 Location: ? Posts: 19,649	Yes! That's the thing! I suppose it would fit an A600 but I can't be 100% sure... Mounting bracket, craddle, same thing, I had to make up a name for it

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Amiga 600 Disk Drive Problems...	lewis_slade	support.Hardware	0	12 May 2012 20:55
Replacement floppy drive internal of Amiga 600	enito	support.Hardware	3	25 February 2008 22:34
Amiga 600 - Hard Disc not recognised	musojon74	support.Hardware	9	24 January 2008 02:32
Setting up Hard drive on Amiga 600	DanE	New to Emulation or Amiga scene	24	23 July 2005 16:44
Amiga 1200/600 internal disk drive	Amiga1992	MarketPlace	3	06 July 2002 06:41

07 October 2001, 21:54	#2
Amiga1992 Registered User Join Date: May 2001 Location: ? Posts: 19,649	Hey Uukrul! 37.300 is just fine, no need to get anything new. You will just have to get a hold of Workbench 2.05 or 2.1 for easier install. It;s very easy to install it inside (plug and play ), however I dont know where you'll get the craddle to lie it in. My drive comes bolted to a metal craddle that lets it sit peacefully inside the miggy. If this came with your 600 I dont know, perhaps you open it up and the cradle is inside. If not, try to look for one, somewhere. It prolly is hard ;/ If I was you I would open the machine up and check it out (no warranties to void ), after unscrewing all the bolts be careful with the plastic holders on the side of the case, dont break them! You will have to push'em with something to open up the case. I have no clues about prices, and I'd like to know because I want to expand my hard drive capacity as well

07 October 2001, 23:10	#3
Uukrul Posts: n/a	Many thanks Akira!! I'll check tomorrow the inners of my A600 BTW, is this http://cgi.ebay.com/aw-cgi/eBayISAPI...tem=1281699842 the craddle you say?

09 October 2001, 22:51	#5
Uukrul Posts: n/a	Well, I finally opened the A600 and the craddle was inside , so no more worries about it. I only need now the 1 meg memory expansion and the harddrive Akira, the harddrive is only connected to the 44 pins connector on the left, isn't it? BTW, did your monitor survive?. I found a doc in Aminet for connect an Amiga to a CPC monitor (soon I'll get a CPC 6128) Salu2

15 October 2001, 13:20	#6
kriz Junior Member Join Date: Sep 2001 Location: No(R)Way Age: 42 Posts: 3,222	the problem is that only an 2.5" Hardrive will fit inside the small A600 case (the same with an A1200) , But you can ofcourse use a standard 3.5" Hardrive but then it would end up hanging on the outside (but it works ).. getting a cheap 2.5" drive is problay the easiest

15 October 2001, 18:29	#7
Amiga1992 Registered User Join Date: May 2001 Location: ? Posts: 19,649	Hey UUkrul Yes, the hard drive is conencted to that thing only. both the IDE and power is transmitted thru it I know a place storing 1MB Chip ram expansions for A600s, with clock and all. I will PM you with the location. I havent taken my monitor to check yet I dont have a CPC monitor BTW, I am connecting my 6128 to the 1084. Cheers,

15 October 2001, 19:51	#8
Uukrul Posts: n/a	Last week on ebay I found two different memory expansions but the same guy won me I can get it at Spain but I don't want to pay $40 for that memory. At least soon I'll put my hands on a cheap CPC 6128

15 October 2001, 20:46	#9
Amiga1992 Registered User Join Date: May 2001 Location: ? Posts: 19,649	i paid 50 for my 6128, that is including shipping fropm the uk . of course without monitor :P and i paid 30 dollars for my 1MB chip expansion.. i dont know if you could get it any cheaper than that ;/

15 October 2001, 20:59	#10
Uukrul Posts: n/a	Final price of the memory expansion was only 10 UK pounds but at this moment I'm out of money ((

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)