Small audio suggestion

08 October 2007, 18:47

Hi,
I noticed that the (lovely!) option that enables the original floppy drive sound within WinUAE can reproduce only one drive at time (i.e. DF0:, DF1:, ...), so if you select DF0: and a game is reading from a disk in DF1:, you hear no sound.

it would be nice to add a "ANY" option to the pulldown menu in order to reproduce sound for every access that AMIGA makes to the floppy drives, don't you think?

P-J · 09 October 2007, 12:38

I'm not sure what you're asking here...

You can select 'DF0:', then select 'A500 (WinUAE Built In)' and repeat for DF1:, DF2: and DF3. Last I checked, this works and gives you sound no matter which of the virtual drives are active.

There is also an alternate sound set available here which can be used in addition to the default one giving you a different acoustic for a second virtual drive.

Or perhaps your 'any' option is the main point of your post? In which case that's up to Toni I guess

10 October 2007, 09:20

thanks for the reply P-J, it was my fault, because I did not noticed that you can assign it to each drive choosing them from the pull-down and then selecting the sound separatedly... thanks!

08 October 2007, 18:47	#1
Zero_G Posts: n/a	Small audio suggestion Hi, I noticed that the (lovely!) option that enables the original floppy drive sound within WinUAE can reproduce only one drive at time (i.e. DF0:, DF1:, ...), so if you select DF0: and a game is reading from a disk in DF1:, you hear no sound. it would be nice to add a "ANY" option to the pulldown menu in order to reproduce sound for every access that AMIGA makes to the floppy drives, don't you think?

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Best Audio Config in Winuae for a Creative X-Fi Audio Card	shaf	support.WinUAE	2	14 June 2012 16:27
Small suggestion re floppy drives	Yesideez	request.UAE Wishlist	5	07 April 2007 05:59
Only suggestion I can think of, but not possible I think.	Ironclaw	request.UAE Wishlist	2	18 March 2006 09:53
Suggestion	BippyM	HOL suggestions and feedback	2	10 February 2003 17:35

09 October 2007, 12:38	#2
P-J Registered User Join Date: Mar 2001 Location: Moorpark, California Age: 43 Posts: 1,153	I'm not sure what you're asking here... You can select 'DF0:', then select 'A500 (WinUAE Built In)' and repeat for DF1:, DF2: and DF3. Last I checked, this works and gives you sound no matter which of the virtual drives are active. There is also an alternate sound set available here which can be used in addition to the default one giving you a different acoustic for a second virtual drive. Or perhaps your 'any' option is the main point of your post? In which case that's up to Toni I guess

10 October 2007, 09:20	#3
Zero_G Posts: n/a	thanks for the reply P-J, it was my fault, because I did not noticed that you can assign it to each drive choosing them from the pull-down and then selecting the sound separatedly... thanks!

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)