|
23 April 2015, 17:08
|
#1 |
|
Registered User
Join Date: Aug 2004
Location:
Posts: 3,333
|
Resolution autoswitch doesn't work reliably
it seems that resolution autoswitch (including VGA mode res autoswitch) doesn't always detect resolution changes.
Specifically, with Workbench set to 1024×768 HighGFX mode, on viewing a 640×512 (PAL) image using MultiView the resolution sometimes doesn't change from superhires (needed for WB) to hires. If you bring Workbench to the front and send it to the back several times, you should see that sometimes the resolution change is detected, sometimes it isn't. Bootable disk with example image attached. Boot using an ECS config with resolution autoswitch enabled, window size at least ~1080x800. |
|
|
24 April 2015, 20:07
|
#2 |
|
WinUAE developer
Join Date: Aug 2001
Location: Hämeenlinna/Finland
Age: 49
Posts: 26,502
|
Fixed. It forgot to set "config was modified" variable which sometimes (timing dependant) caused config system to not notice pending resolution change.
|
|
|
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | |
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Resolution autoswitch scanlines | Zilog | support.WinUAE | 1 | 02 January 2015 09:11 |
| Resolution autoswitch problem! | amilo3438 | support.WinUAE | 15 | 05 July 2013 09:27 |
| Resolution autoswitch broken | Leandro Jardim | support.WinUAE | 4 | 08 September 2012 22:23 |
| Resolution Autoswitch and Interlace | Leandro Jardim | support.WinUAE | 4 | 06 April 2011 10:47 |
| Resolution autoswitch | reenstix | support.WinUAE | 1 | 05 March 2011 11:54 |
|
|
