|
03 July 2009, 19:40
|
#1 |
|
Moderator
Join Date: Nov 2004
Location: Eksjö / Sweden
Posts: 5,604
|
A600 Custom RF shield?
A600 portable project.
I'm looking to replace the original RF shield top half of my A600 with a thicker metal plate, 300x100x1mm or so. This is to have something sturdier to fasten the L-brackets to that are to hold the lower half of the LCD screen hinge. Normal sheet metal will do, I guess? It's either that, or I put some metal on the inside of the plastic case. The Joytech 8" screen has a nice and firm hinge, very good. But I'd rather not put the stress on the plastic case, as that would probably give a crack in it sooner or later... The solution I have to come up with atm is how to fasten the RF shield replacement _solidly_ inside with a minimum of fuss. Bend the sides at right angles and make screw holes in the original lower half of the RF shield? Any advice appreciated! Last edited by Photon; 04 July 2009 at 00:38. Reason: changed an adjective, actually! |
|
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | |
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| My Custom A600... | mfilos | Hardware mods | 148 | 31 May 2013 16:30 |
| Nvidia Project Shield | john4p | News | 1 | 08 January 2013 20:19 |
| Scandoubler and RF shield. | asm1 | Hardware mods | 7 | 20 February 2009 20:43 |
| A1200 RF Shield - Yay or Nay? | thgill | Hardware mods | 30 | 22 July 2008 09:18 |
| A500 RF Shield Remove Backplane ? (How?) | chaoticjelly | support.Hardware | 11 | 17 July 2007 00:16 |
|
|
