20 August 2022, 10:30 | #41 |
0ld0r Git
Join Date: Mar 2009
Location: Cornwall, UK
Posts: 1,626
|
@ macce2
See PM for eBay link. |
07 September 2022, 20:13 | #42 |
Retro maniac
Join Date: May 2005
Location: Finland
Age: 49
Posts: 1,222
|
Ok, thanks everyone for help; especially Kin Hell !
I purchased and got proper active adapter from Romania, and I got my HP hard drive detected eventually ! However, I think I'm a little disappointed because of the relatively low file access speed of the drive. SysInfo gives only about 2/3 of the speed of my old Fujitsu drive. I used Phase5 Scsi configuration tools to manage the speed settings etc. The handshake is of lower value !? Any ways to get more out of my new drive, in terms of performance (speed) ?! I thought it should be as fast, or even faster than my old drive; which doesn't seem to be the case (!?). |
09 September 2022, 09:45 | #43 |
0ld0r Git
Join Date: Mar 2009
Location: Cornwall, UK
Posts: 1,626
|
Glad you got sorted eventually & sorry to hear you feel disappointed with the performance.
At best, the Fastlane can only manage 7 MB/s asynchronous and 10 MB/s synchronous transfer speeds, less overheads. However, the overheads on the SCSI bus will still give you far superior performance over IDE overheads using hard drives, CF etc. It's what SCSI was all about. - Less impact on your CPU. |
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
Thread Tools | |
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Help request for UltraSCSI 68pin to A3000 - Drive not seen in HDToolbox | csanii | support.Hardware | 9 | 19 February 2020 11:24 |
Fastlane card and SCSI | macce2 | support.Hardware | 12 | 01 December 2019 20:59 |
Fastlane Z3 / SCSI problems | amigasith | support.Hardware | 21 | 06 February 2016 11:13 |
"drive does not support scsi inquiry method!" | donnie | project.ClassicWB | 16 | 08 August 2010 13:05 |
Can I cut the last part of a 68pin SCSI cable??? | keropi | support.Hardware | 2 | 22 January 2007 22:18 |
|
|