29 March 2009, 00:17 | #1 |
Registered User
Join Date: Sep 2006
Location: Thunder Bay, Canada
Posts: 4,323
|
NTSC A500 Pal/NTSC mod pics
Hi all
i figured it was time to mod my NTSC A500 (V5) for multiregion boot so here it is... I ran the wires to a jumper block so i can use a regular 2 pin female header block with a switch on it to toggle the modes and also allow unplugging etc. I haven't decided where i am going to mount the switch yet. I just broke off the pin on the chip and then bent the socket wire back over the socket and then soldered the wires on to each side of the jumper block Last edited by kipper2k; 29 March 2009 at 00:25. |
29 March 2009, 07:22 | #2 |
I hate potatos and shirts
|
Just remember to use pull-up resistor to not fry the Agnus with a floating TTL level and you are set.
|
29 March 2009, 07:56 | #3 |
WinUAE developer
Join Date: Aug 2001
Location: Hämeenlinna/Finland
Age: 49
Posts: 26,602
|
|
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
Thread Tools | |
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
newbie needs help with A500 ntsc / pal issue | inkalsecurity | support.Hardware | 11 | 10 July 2013 15:52 |
Lotus Esprit PAL/NTSC switcher not working on A500+ | lordofchaos | support.Games | 0 | 08 May 2013 20:00 |
ntsc and pal hardware A500 | heALer | support.Hardware | 19 | 09 October 2010 09:51 |
A500+ from Pal to NTSC | desantii | support.Hardware | 8 | 13 October 2009 16:27 |
NTSC to PAL ...what's next? | NfernalNfluence | support.Hardware | 7 | 28 July 2007 12:19 |
|
|