So ..the centre off DPTT switch arrived ..and you can see it hanging off to the left of the photos ..
I will need to extend the wires with some longer Dupont wires to mount it.
There is a photo showing the switch in the Octopussy mode and CF card powered with KS 3.14 4th photo
..and a photo with the switch in Octagon mode with KS3.14 and the CF card powered ...
this results in a guru error ..but wait a few seconds and it will reboot to 3.14 insert disk screen ..but obviously wont access the CF hard drive..
the 2 middle photos ..
and finally the switch in centre off position and KS1.3 enabled ..which cuts power to the CF card ..so no hard drive...and octagon mode enabled as J1 on the HC533 is open as well (centre off)
The A500 is now ready to simply accept a disk ..and run from that. 1st photo
rgds
VS
Last edited by Vipersan; 26 May 2020 at 18:54.
|