View Single Post
Old 22 May 2021, 11:41   #2
ChadsArcade
Registered User

 
Join Date: Jan 2018
Location: Chorley
Posts: 31
I'm interested in an RGB to HDMI solution for my CDTV, the replicator boards look good but I'm not sure about clearance, and height in particular. I think the pi would need to be soldered directly to the board to minimise the height.

I'll have a measure up and drop you a PM, worst case I could fit it to my Rev5 A500 as my current standard build one fouls my ROM switcher.
ChadsArcade is offline  
 
Page generated in 0.04848 seconds with 11 queries