It works, Debian Sarge successfully installed.
dmesg:
Code:
Linux version 2.4.27-amiga (root@dl360-g3) (gcc version 2.95.4 20010319 (prerelease)) #1 Wed May 31 16:30:52 MDT 2006
Amiga hardware found: [A4000] VIDEO BLITTER AUDIO FLOPPY A4000_IDE KEYBOARD MOUSE SERIAL PARALLEL A3000_CLK CHIP_RAM PAULA LISA ALICE_PAL ZORRO3
On node 0 totalpages: 131072
zone(0): 131072 pages.
zone(1): 0 pages.
zone(2): 0 pages.
Kernel command line: root=/dev/hda1
Console: colour dummy device 80x25
Calibrating delay loop... 0.97 BogoMIPS
Memory: 515572k/524288k available (1544k kernel code, 7056k data, 116k init)
kmem_create: Forcing size word alignment - mm_struct
kmem_create: Forcing size word alignment - filp
kmem_create: Forcing size word alignment - dquot
Dentry cache hash table entries: 65536 (order: 7, 524288 bytes)
Inode cache hash table entries: 32768 (order: 6, 262144 bytes)
kmem_create: Forcing size word alignment - inode_cache
Mount cache hash table entries: 512 (order: 0, 4096 bytes)
kmem_create: Forcing size word alignment - bdev_cache
kmem_create: Forcing size word alignment - cdev_cache
kmem_create: Forcing size word alignment - kiobuf
Buffer cache hash table entries: 32768 (order: 5, 131072 bytes)
Page-cache hash table entries: 131072 (order: 7, 524288 bytes)
POSIX conformance testing by UNIFIX
Zorro: Probing AutoConfig expansion devices: 3 devices
Zorro: Address space collision on device Zorro device 07db0300 (Hacker Test Board) [10000000:2fffffff]
Linux NET4.0 for Linux 2.4
Based upon Swansea University Computer Society NET3.039
Initializing RT netlink socket
Starting kswapd
kmem_create: Forcing size word alignment - file_lock_cache
VFS: Disk quotas vdquot_6.5.1
Journalled Block Device driver loaded
devfs: v1.12c (20020818) Richard Gooch (rgooch@atnf.csiro.au)
devfs: boot_options: 0x0
Console: switching to colour frame buffer device 80x25
fb0: Amiga AGA frame buffer device, using 1280K of video memory
clgen: Driver for Cirrus Logic based graphic boards, v1.9.9.1
clgen: no supported board found.
pty: 256 Unix98 ptys configured
Amiga-builtin serial driver version 4.30
ttyS00 is the amiga builtin serial port
Amiga mouse installed.
kmem_create: Forcing size word alignment - blkdev_requests
FD: probing units
found fd0
Unable to get major 2 for floppy
RAMDISK driver initialized: 16 RAM disks of 4096K size 1024 blocksize
loop: loaded (max 8 devices)
Uniform Multi-Platform E-IDE driver Revision: 7.00beta4-2.4
ide: Assuming 50MHz system bus speed for PIO modes; override with idebus=xx
ide0: Gayle IDE interface (A4000 style)
hda: UAE-IDE debian.vhd, ATA DISK drive
ide0 at 0x80dd2020 on irq 12
hda: attached ide-disk driver.
hda: 4096000 sectors (2097 MB) w/256KiB Cache, CHS=16253/4/63
hda: task_no_data_intr: status=0x51 { DriveReady SeekComplete Error }
hda: task_no_data_intr: error=0x04 { DriveStatusError }
Partition check:
/dev/ide/host0/bus0/target0/lun0: RDSK p1 p2
SCSI subsystem driver Revision: 1.00
kmod: failed to exec /sbin/modprobe -s -k scsi_hostadapter, errno = 2
kmod: failed to exec /sbin/modprobe -s -k scsi_hostadapter, errno = 2
Initializing Cryptographic API
NET4: Linux TCP/IP 1.0 for NET4.0
IP: routing cache hash table of 4096 buckets, 32Kbytes
TCP: Hash tables configured (established 131072 bind 65536)
NET4: Unix domain sockets 1.0/SMP for Linux NET4.0.
EXT3-fs: INFO: recovery required on readonly filesystem.
EXT3-fs: write access will be enabled during recovery.
kjournald starting. Commit interval 5 seconds
EXT3-fs: recovery complete.
EXT3-fs: mounted filesystem with ordered data mode.
VFS: Mounted root (ext3 filesystem) readonly.
Adding Swap: 122968k swap-space (priority -1)
EXT3 FS 2.4-0.9.19, 19 August 2002 on ide0(3,1), internal journal
eth0: A2065 at 0x00e90000, Ethernet Address 00:80:10:4d:5b:61
fd0: accessing DD 3.5-disk with Amiga-layout
fd0: accessing DD 3.5-disk with Amiga-layout
FAT: bogus logical sector size 17264
VFS: Can't find a valid FAT filesystem on dev 02:00.
fd0: accessing DD 3.5-disk with Amiga-layout