Thread: M1438 Pictures
View Single Post
Old 28 May 2021, 22:31   #26
Retrorepair
Registered User

 
Join Date: May 2020
Location: Rochford
Posts: 25
It could be a bad connection on the neck board, sounds like green is missing. I actually didn't have a picture when putting it back together this evening, wiggling the neck board connector brought the picture back so it could be worth a look.

But yes, if you could I think I'm out of ideas as to what's happening now (or not happening).

The area where the neck board ribbon meets the main board would be good to see. Every picture I've seen has this area covered up by the ribbon so I might have missed something there.

I've discovered 800x600 will display fine, if a little narrow. All other resolutions seem to be doubled or trippled on the horizontal though. I assume the relay should click when is switches resolutions?
Retrorepair is offline  
 
Page generated in 0.06384 seconds with 11 queries