View Single Post
Old 14 January 2021, 14:21   #8
MBG
Registered User

 
Join Date: Jan 2021
Location: NL
Posts: 42
On a piece of paper I drew out where I wanted the holes for the buttons and joystick.
Then I punched dimples to mark the spots.
Next I drilled small (about 3 mm) holes all the way through the board.
These holes make it easier to drill large (28 mm) holes from both sides of the board with a forstner bit.
Drilling from both sides made it a little easier to get nice clean holes.
I still had to sand them a bit though.
Attached Thumbnails
Click image for larger version

Name:	Joystick build 20 (small).jpeg
Views:	55
Size:	180.0 KB
ID:	70350   Click image for larger version

Name:	Joystick build 30 (small).jpeg
Views:	56
Size:	240.7 KB
ID:	70351  
MBG is offline  
 
Page generated in 0.06416 seconds with 12 queries