View Single Post
Old 19 January 2017, 04:50   #5
briansallee
 
Posts: n/a
I'll snap a picture next time I am down at the machine - but it is a rev 4 version of this card (notice the jumpers along the top) The silk screening for the jumpers and what I would assume are the options for the jumpers based on grouping matches the table on this page. http://amiga.resource.cx/exp/gforce2030)

Note for instance in the PDF the positions of JP10,JP13 (Both for Ram config) and also the large bank of jumpers at the bottom of the card.

My card has the main jumper block at the top, and JP10 is in a different grouping of jumpers from JP13,

So it could have been an earlier revision of the board in the manual, but if it is, then the documentation on the jumpers and such don't apply.
 
 
Page generated in 0.04485 seconds with 11 queries