So I have been playing around with the DKB WildFire expansion on one of my A2000 configurations, but didn't get very far with it. While it boots, what appears is a series of blue- and red-moving stripes, then it stops at a blue screen.
Looking through the log files, I see a bunch of messages like these.
Quote:
50-339 [32 179=307]: Illegal instruction: 0808 at 0028000A -> 0028000A
51-554 [93 143=110]: warning: WRITE.W to address $ffe8fffa : value $2700 PC=0028000a
54-068 [217 152=243]: SERIAL: period=40, baud=115200, hsyncs=1, bits=8, PC=28000a
54-068 [217 219=295]: cia_wput: unknown CIA address FFBFFFFC=2700 0028000A
|
And if I turn on cycle-exact, I get a HALT7.
According to the manual, you can boot your A2000 hard drive as normal then run the installation program, then mount the expansion afterwards. The install program forces you to install the Ethernet tools as well, but installing them causes the similar "file not found" message. I got the disk from amiga.resource.cx. I am going to copy the tools manually, and see how that goes.
Log and config in ZIP file.