View Single Post
Old 24 January 2016, 19:32   #6
Registered User

8bitbubsy's Avatar
Join Date: Sep 2009
Location: Norway
Posts: 1,584
The top pin on the left capacitor in picture #2/#3 doesn't look to be connected to the trace at all, hard to say on the pictures, but have you tried to measure the continuity with your multimeter on those too?
EDIT: These two caps are crossover caps in the last audio stage, so if they're not connected then you will get no channel audio. I suspect that this is the issue. If you only connect one audio RCA/phono at the time, it will leave an internal connector switch open and thus the sound is bridged in mono between both connectors, so this cap could still be the problem...

Last edited by 8bitbubsy; 24 January 2016 at 20:01.
8bitbubsy is offline  
Page generated in 0.05189 seconds with 11 queries