English Amiga Board - View Single Post

Zetr0 · 26 May 2010, 14:36

@paul

my friend you would be looking for the DKB WildFire 060

Front

Back

Features

processor 68060 @ 50 MHz
memory four 72 pin SIMM sockets accept 128 MB RAM
supports 4, 8, 16, 32 MB SIMMs, 60-80 ns
64 bit interleaved RAM access if identical SIMMs are installed in alternate banks (U312 / U314 and U313 / U315)
only SIMMs with 1K refresh rate are supported (SIMMs with 4K refresh rate don't work)
Fast SCSI 2 controller 10 MB/s max transfer speed
50 pin internal header
50 pin external high density connector
uses wildfirescsi.device
Ethernet DEC Tulip 21040, the only Ethernet controller in Amigas that DMAs directly into fast 32 bit memory
up to 100 Mb/s transfer speed
10Base-T connector
internal slot for the optional 10Base-2 connector
has SANA II, but no MNI driver
notes works only with Kickstart 3.x
- flash ROM for firmware upgrades
- two PCI bus slots (one for the Inferno graphics board)
- JP104 jumper setting: ON = 70 or 80ns / OFF = 60ns (all other jumpers are reserved)
- configuration screen can be activated by holding right mouse button during startup

The Blizzard 2040/2060 on the other hand is a good contender for the top spot, it can be upgraded to a PPC via a prototype PPC adapter, however it is very unlikey to find one of these in the wild.

hope that lot helps paul =D

(thanks to amiga.resource for images and informations)

26 May 2010, 14:36	#2
Zetr0 Ya' like it Retr0? Join Date: Jul 2005 Location: United Kingdom Age: 49 Posts: 9,768	@paul my friend you would be looking for the DKB WildFire 060 Front Back Features processor 68060 @ 50 MHz memory four 72 pin SIMM sockets accept 128 MB RAM supports 4, 8, 16, 32 MB SIMMs, 60-80 ns 64 bit interleaved RAM access if identical SIMMs are installed in alternate banks (U312 / U314 and U313 / U315) only SIMMs with 1K refresh rate are supported (SIMMs with 4K refresh rate don't work) Fast SCSI 2 controller 10 MB/s max transfer speed 50 pin internal header 50 pin external high density connector uses wildfirescsi.device Ethernet DEC Tulip 21040, the only Ethernet controller in Amigas that DMAs directly into fast 32 bit memory up to 100 Mb/s transfer speed 10Base-T connector internal slot for the optional 10Base-2 connector has SANA II, but no MNI driver notes works only with Kickstart 3.x flash ROM for firmware upgrades two PCI bus slots (one for the Inferno graphics board) JP104 jumper setting: ON = 70 or 80ns / OFF = 60ns (all other jumpers are reserved) configuration screen can be activated by holding right mouse button during startup The Blizzard 2040/2060 on the other hand is a good contender for the top spot, it can be upgraded to a PPC via a prototype PPC adapter, however it is very unlikey to find one of these in the wild. hope that lot helps paul =D (thanks to amiga.resource for images and informations) Last edited by Zetr0; 26 May 2010 at 14:45.