Quote:
Originally Posted by orange
hm, yes, but are you sure? because I noticed the blanking ground goes to LOGIC ground and there is 250 ohms between it and video GND on my A1200 (if I measured it correctly)
about +3, it takes 15min to change the belt, I do it without completely dismantling the drive. of course, finding the new belt is another story.
|
Hi there orange,
which pin are you meaning? pin 16 is Blanking Signal ( RGB Selection) and pin 18 is Blanking ground in the scart plug. Note that pin 16 in the scart is fed via a resistor from pin 23 at the Amiga end.
I have eventually found the information that I used to make my leads from and they all work with my 1200, 600.500 plus and 500.
I did change a belt on someone else's +3 about 7 years ago and getting a belt back then was pretty hard, I haven't got my speccy out yet as I have been doing other stuff, but one day I will
Good luck with your cable