English Amiga Board - View Single Post

kipper2k · 29 March 2009, 00:17

Hi all

i figured it was time to mod my NTSC A500 (V5) for multiregion boot so here it is...

I ran the wires to a jumper block so i can use a regular 2 pin female header block with a switch on it to toggle the modes and also allow unplugging etc. I haven't decided where i am going to mount the switch yet.

I just broke off the pin on the chip and then bent the socket wire back over the socket and then soldered the wires on to each side of the jumper block

29 March 2009, 00:17	#1
kipper2k Registered User Join Date: Sep 2006 Location: Thunder Bay, Canada Posts: 4,323	NTSC A500 Pal/NTSC mod pics Hi all i figured it was time to mod my NTSC A500 (V5) for multiregion boot so here it is... I ran the wires to a jumper block so i can use a regular 2 pin female header block with a switch on it to toggle the modes and also allow unplugging etc. I haven't decided where i am going to mount the switch yet. I just broke off the pin on the chip and then bent the socket wire back over the socket and then soldered the wires on to each side of the jumper block Last edited by kipper2k; 29 March 2009 at 00:25.