[Tavis]

Originally Posted by jbilander

Cool, it should work on 1.3, just some heads-up regarding the A1000. Use a proper gender-changer-plug for the parallel port, my advice. You might get away with a straight 1:1 plug if you remove the JP1 solder jumper blob (because otherwise the /RESET-line will be asserted as pin 16 is GND on the A1000). We thought of this potential problem of using a straight gender-changer when we did the pin assignments, hence why pin 23,24,25 are not connected to GND since the A1000 has +5V on pin 23. Double-check with the pinout on the schematic and don't plug in anything else on the A1000 with such plug without double-checking pinout. It'll most likely damage your CIA chips.

https://github.com/jbilander/sdbox/b...ics_rev_1a.png

https://github.com/jbilander/sdbox/b...rallel-port.md

Also on a stock A1000 you have very limited amount of memory so make the FAT-partition smaller, like a few hundreds of megabytes or so. A big partition allocates more memory from the system.

Yikes. I was about to just plug the SDBox into it.