So for the rj1307 (2mb agnus) [
https://www.amibay.com/showthread.ph...00-Amiga-CDTV] I used the following memory: HM514260AJ8 (262, 144-Word x 16-Bit Dynamic Random Access Memory)
And I bought cheap 74f00 and 74F139 from ebay. China/HK.
This is for my rev 6. Other than the difference in memory the components are all in place.
I have soldered the module in place and in the correct orientation. When I boot, I see only 0.5 chip.
I made sure jp2 was bridged across the top and the trace is cut from bottom to mid. Jp7a also has had bottom two trace cut.
I guess it is either
. The memory is not compatible or not working
. The Chinese chips are all lies
. Bad soldering
I doubt it's the mem because I bought that here from a seller. It was originally intended for back up a1200 2b memory but I assumed it would work.
Regards.