Maybe this thread would be better in winuae.support
but now I ask my questions here:
First, I get no reaction on this commands:
Code:
mg <address> Memory dump starting at <address> in GUI. ; no reaction
dg <address> Disassembly starting at <address> in GUI. ; no reaction
rc Show CPU instruction or data cache contents. ; no reaction
rcd ; no reaction
(rc,rcd the same output on A1200 configuration ?)
And this command shows always the complete list:
Code:
i [<addr>] Dump contents of interrupt and trap vectors.
; this is only i but not for instance i 6c
Now I need (wish) an explanation or simple example for following debugger commands:
Maybe also a link to an old thread would help.
Code:
b Step to previous state capture position.
I <custom event> Send custom event string
di <mode> [<track>] Break on disk access. R=DMA read,W=write,RW=both,P=PIO.
Also enables level 1 disk logging.
did <log level> Enable disk logging.
wd [<0-1>] Enable illegal access logger. 1 = enable break.
il [<mask>] Exception breakpoint.
If I want copy eg the content of the color registers. This is difficult, because:
Code:
>e ; shows always the complete list
000 BLTDDAT 0000 100 BPLCON0 0200
002 DMACONR 03F0 102 BPLCON1 0000
004 VPOSR 8000 104 BPLCON2 0024
006 VHPOSR 0007 106 BPLCON3 0C00
better would be:
Code:
>e [<address>] [<lines>]
>e 180 16 ; eg for color registers
Or, why is this not shown?
Code:
>m dff000
00DFF000 **** **** **** ****Custom chipset* **** ****************
00DFF010 **** **** **** ****Custom chipset* **** ****************
>d dff000 ; ok that makes not sense...
00DFF000 ffff ILLEGAL
00DFF002 03f0 8000 BSET.B D1,(A0,A7.L[*8],$ff) == $00c633ff (68020+) [00]
00DFF006 0007 ffff OR.B #$ff,D7
00DFF00A 6807 BVC.B #$07 == $00dff013 (T)