English Amiga Board - View Single Post - Amiga 600 schematics nearly put into Kicad

Mick · 18 August 2019, 14:13

I've uploaded my progress to date into the zone, maybe Stedy or someone can host the files or they'll disappear after 60 days?

If anyone is looking to finish it I think it's basically a case of checking PCB dimensions, connector locations, hole diameters and pad sizes. Also, checking schematics in case of any mistakes but that is what Stedy is already kindly doing. The whole layout is accurate to what AmigaPCB says for a Rev 2A PCB (and using datasheets for footprints) rather than any physical board. Any skilled board designers can probably route it much better as well.

If anyone has the overall length and width for an A1200 rev 1.x I was going to give it a try since about half of the A600 schematics can be recycled, in fact I've already drawn them up and got all footprints ready.

18 August 2019, 14:13	#92
Mick Registered User Join Date: Jan 2004 Location: Yorkshire Posts: 714	I've uploaded my progress to date into the zone, maybe Stedy or someone can host the files or they'll disappear after 60 days? If anyone is looking to finish it I think it's basically a case of checking PCB dimensions, connector locations, hole diameters and pad sizes. Also, checking schematics in case of any mistakes but that is what Stedy is already kindly doing. The whole layout is accurate to what AmigaPCB says for a Rev 2A PCB (and using datasheets for footprints) rather than any physical board. Any skilled board designers can probably route it much better as well. If anyone has the overall length and width for an A1200 rev 1.x I was going to give it a try since about half of the A600 schematics can be recycled, in fact I've already drawn them up and got all footprints ready. Last edited by Mick; 18 August 2019 at 14:32.