First up when I install WB3 or ClassicWB using SFS and scsi 43.45 and then run Check4GB I get ok? on the last partition. Is this ok or have I messed something up?
Then when I make a plain install of WB3 and again install SFS and scsi.device as above I still get that problem, but then Workbench does not report the correct drive sizes as can be see in the next screen shot. What do I need to install or patch to make these reading correct like that are in CWB?
Finally, no matter which version of CWB I try using (Full, 3.9 and P96 attempted thought P96 only briefly), I cannot get P96 to work with my CV64/3D. Usually it just comes up on boot saying CVision3D is not executable. I know the card is fully working as I have installed P96 on a plain WB3 and it works there (you can see that on the above picture).
Some help would be appreciated.