1081 monitor rubber feet?
Does anybody sell replacement rubber feet for 1081 monitors?
|
|
1 Attachment(s)
Quote:
I’ll work through that page to see if I can find something that might work. They need to fit in a hole that’s about 11mm in diameter and 8mm deep. |
1 Attachment(s)
So this is what I've ended up with. Original on the right for comparison.
They're made with Shore 70A TPE, which is "like a running shoe sole". They're a good fit in the hole. I don't know how far the originals stuck out of the hole, but these have a foot part that's 2mm thick. Once fitted, that's all you can see, and it looks neat, plus you only see them if you turn the monitor over, so I think that's all ok. |
1 Attachment(s)
This is the point in the story where the protagonist discovers that the front feet are not the same as the back feet.
Why would they do that? Why? EDIT: It's not just the slot, the front feet have a wider foot section, are angled, and are much taller. |
1 Attachment(s)
Front feet done.
|
Great job! :-)
|
All times are GMT +2. The time now is 22:29. |
Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2024, vBulletin Solutions Inc.