English Amiga Board

English Amiga Board (http://eab.abime.net/index.php)
-   support.Hardware (http://eab.abime.net/forumdisplay.php?f=20)
-   -   New ACA500+ user - Having issues installing Workbench (http://eab.abime.net/showthread.php?t=97101)

MyChickenNotRaw 17 April 2019 19:51

New ACA500+ user - Having issues installing Workbench
 
Hi all,

I have tried to use the ACA500plus automatic installer menu to install workbench onto a freshly formatted FAT32 card.

It goes through process of mounting the 7 virtual disk images and then loads into Workbench but I get the following message:
"Not a DOS disk in device ACAVD6"


If I try and use the F7 non auto method I see the following disks on the workbench screen.

Ram Disk
Install 3.1
ACAVD1:NDOS
ACAVD2:NDOS
ACAVD3:NDOS
ACAVD4:NDOS
ACAVD5:????

I have tried flashing all the firmware's on the ACA support page and this doesn't seem to change anything.

My a500+ has a gotek which allows me to mount the workbench ADFs and install successfully but I would rather use the ACA autoinstall to get everything fully supported. Also I'm worried a might have faulty card.

Thanks in advance!
Mark


All times are GMT +2. The time now is 11:12.

Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2022, vBulletin Solutions Inc.

Page generated in 0.04289 seconds with 11 queries