|28 May 2005, 16:52||#1|
I need one output line...
I have successfully built and uploaded to AMINET an A-D Converter.
This is primarily designed for WinUAE but works on genuine AMIGAs also.
It is in the hard/hack/ drawer of AMINET as:-
It works well enough as a Voltmeter, and with additional HW/SW as
an RF Power Meter and AF Wattmeter...
I have hit a snag with my latest project tho`.
This snag ONLY occurs under WinUAE.
I am building a Data-Logger/(Transient Recorder|) for genuine MIGGYs
and WinAUE using the same HW and SW.
As there are NO Output lines that I can see I had to make my
HW control my SW instead of the reverse.
I use the two buttons of the PC games port as my Inputs,
one controls the SW the other is the serial data input.
This is the problem:-
Every so often there is a glitch in the reading, which is a function
of Windows NOT WinUAE.
I would like yo be able to control my HW from a single control
line from say the parallel port or maybe the serial port.
Is this possible under WinUAE?
If so then can any suggest an AMIGA assembler routine
that I can use to give me one Output line and one Input line?.
Many thanks in advance for ANY replies.
Author of the TestGear?.lha and related projects in AMINET.
|Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)|
|Thread||Thread Starter||Forum||Replies||Last Post|
|garbage video output on 1200||hardwir3d||support.Hardware||2||15 March 2005 12:11|
|Disk Swapper command line options ?||Leo42||support.WinUAE||1||23 December 2004 18:01|
|command line to start a confil + start the game||Unregistered||New to Emulation or Amiga scene||4||17 October 2004 10:31|
|command line?||Drake1009||support.WinUAE||7||14 August 2004 17:17|
|Blinking Taskbar Line in FS mode ;((||Leo42||support.WinUAE||3||31 May 2003 13:48|