Partitions not showing in Real A1200

Hi,

My first post and unfortunately is a bit of an odd issue this. Ive been in to the emulation scene for many years now and been tinkering with winuae etc for a while.

So I decided to put a 60gig HDD in to my A1200 with an 8mb expansion board.

In winuae I have set up the drive with HDToolBox and all SFS as follows:

DHO: Small WB partition
DH1: Small Apps Partition
DH2: Large Demos Partition
DH3: Large Games Partition.

After spending hours transferring WHDLoad Gemes/Demos and general apps on to the partitions, it all runs swimminly beautiful in winuae.

Now, here is my issue:

I remove the HDD and plug it in to my beloved Miggy, the system boots up straight in to WB as expected at uber speed....but where are my other partitions DH1:2: AND 3??

Nothing, zilch, nadda

So I boot up HDToolBox and its all there, the partitions, advanced options with SFS\00 etc all set to 1FE00 as expected.

Please see the below screen shots, can someone help??

Winuae (all present and correct)
[IMG][/IMG]

Real Amiga a1200 WB Screen



Advanced Options screen (same for all)



DH0:1:2:3 Screens







I would really appreciate some advice.

Cheers

Darren

[Arnie]

Does it show the partitions as mounted using the info command from cli?

[Toni Wilen]

Most likely usual >4G wrap around. (Second partition end is outside of first 4G)

Check http://eab.abime.net/showthread.php?t=61666

Thanks for the quick response, I will have a good read over the next couple of days and see if I can resolve. Cheers

Hey, I updated the scsi.device to v 43.24 and its all good now all partitions show in my Miggy

Thanks for the steer and resolution