Wicher 500i classic turbo card for A500 (internal version)

[AiO]

Hi there,

I just resurrected my Wicher500i (Rev 2.b, semi-upgraded to c at some point, don't know what was done). My card works kund of flawless on most frequencies. Even can run 50MHz - but for temperature reasons i stay at or below 42MHz. Love this card.

I'm trying to get the an ENC28J60 working with it. I followed the connection instructions found on the 500iex but grab 3.3V from another expansion that has a voltage regulated 3.3V available on a pin.

But I can not get these drivers to work at all. Are there some good guide/manual on how to get the SPI-ethernet stuff working? I grabbed them from the 2.9 disk.

At some point it identified as an sdcard reader, but mostly it says "none..." at the SPI information in WicherPrefs.

Tnx in advance!

Edit: Oh shit. There is slightly different pinout on 500i. Oh well... I'll redo it tomorrow. Hopefully the module is not broken

Edit2: Nope... The Rev 2.B has the 10-pin connector. Like this https://retro.7-bit.pl/images/spi_pin.png And i re-checked the connections i did to the SPI module. However. It seems this link (which is the most similar I have) https://retro.7-bit.pl/?lang=en&go=p...ame=wicher500i do not mention how to hook up an ENC28J60, while this link (2C) does: https://retro.7-bit.pl/?lang=en&go=p...&name=WI500I2C ... Am I at a loss here then? It's simply not supported, or is it just that my header has 5V instead of 3.3V that made 7-bit remove it? (I remember I saw the connection guide early on).