08 November 2013, 15:19 | #1 |
Registered User
Join Date: Aug 2012
Location: Australia
Posts: 651
|
Eyetech 4 way buffered IDE interface
Howdy,
I picked up a second hand 4 way buffered IDE connector however I have noticed its missing some pins on the IDE connector. Anyone else have one to compare? The connectors are like this: CDPlus CH2S (3.5") 2nd 3.5HD CH2M (3.5") 3rdHD/2ndCD CH1S (2.5") (guide says connect to amiga here) internalHD CH1M (2.5") If you look at the connector orientated with the connections as above the following pins are missing. Bottom left on the CH1S connector (looks like the pin 1 reset pin) Bottom right on the CH2S connector (CDPlus) (looks like pin 39 dasp-) Is it supposed to be like this or has some idiot cut some of the pins off? I don't think the reset pin is an issue, if it wasn't shipped like this i guess someone did it to fix a problem with their hdds and/or cdroms not initialising in time after a soft reset. But will pin 39 cause problems on the CH2M connector? Last edited by Vot; 08 November 2013 at 17:12. |
08 November 2013, 17:15 | #2 |
Registered User
Join Date: Aug 2012
Location: Australia
Posts: 651
|
Looks like maybe this is the way they come shipped. Mine is a different revision but same pins missing as pictured here.
http://www.amibay.com/showthread.php?t=32512 Last edited by Vot; 09 November 2013 at 00:21. |
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
Thread Tools | |
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Buffered IDE interface A600/A1200 | DDNI | MarketPlace | 4 | 05 April 2008 19:11 |
Wanted: buffered IDE interface | Merlin | MarketPlace | 20 | 08 March 2008 21:32 |
FS: Eyetech EZCD 4-Device Buffered IDE Interface | lopos2000 | MarketPlace | 4 | 16 October 2006 15:43 |
4-Way Buffered IDE Interface | DDNI | support.Hardware | 8 | 30 June 2006 11:35 |
A1200 Buffered IDE Interface + Loads More! | Mick_AKA | MarketPlace | 0 | 05 February 2004 01:23 |
|
|