Help with PFS3 on CF

[DonutKing]

Need some assistance please
Trying to setup a 16GB CF card for my A1200 rev 1D4 with 3.1 ROMs.


I followed the guide here: https://16bitdust.wordpress.com/2015...nuae-and-pfs3/


I have partitioned the card into a 1024MB partition for DH0, and the remaining space as DH1. installed PFS3 on both partitions and then installed latest version of ClassicWB ADVSP.

Everything works fine in WinUAE but when I install it into my Amiga I get the below error on boot:


If I click OK I get told there is no disk in DH0, and eventually after continuing to click OK I get dumped to a CLI prompt. I can't open either DH1: or DH0: - it just asks me to insert it into any drive.

I am using scsi.device 44.2 and placed it in the DH0 DEVS folder.

Here's what sysinfo says about DH0:



Here's HDToolbox settings:





Any assistance would be appreciated

[thomas]

Originally Posted by DonutKing

I am using scsi.device 44.2

This is known to cause issues. Try again with 43.45.

[DonutKing]

Thanks so much, that fixed it