05 February 2020, 00:37 | #1 |
Registered User
Join Date: Jan 2020
Location: UK
Posts: 108
|
A4000D memory
Hi, can anyone tell me if I can use a 4mb 72pin simm in the (U621) chipram slot, then 2 8mb 72pin simms in the remaining fast ram banks, rather than 4x4mb sticks? Also, does it need to be parity or non parity?
Cheers! |
05 February 2020, 00:53 | #2 |
Professional slacker!
|
Iirc you can use an 8mb stick as chip ram (will show as 2mb) and 2x 8mb instead of 4x 4mb. Again iirc must be double sided. Sorry been out of the loop a while, might be a jumper to change for the 2x 8mb
|
05 February 2020, 04:32 | #3 |
Registered User
Join Date: Sep 2004
Location: Tacoma, WA USA
Age: 52
Posts: 1,915
|
No jumpers needed to run two 8MB simms as 16MB. Must be put in 2nd and 4th slots I believe.
|
05 February 2020, 10:45 | #4 |
Registered User
Join Date: Sep 2008
Location: Somewhere
Posts: 223
|
Yes, you can use a 4MB SIMM in the Chip RAM slot (U261). Set the jumpers as following: J213=8M, J214=8M.
|
05 February 2020, 12:41 | #5 |
Registered User
Join Date: Jan 2020
Location: UK
Posts: 108
|
|
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
Thread Tools | |
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Memory watch point on blitter writing to memory? | mcgeezer | support.WinUAE | 12 | 26 June 2019 22:12 |
WinUAE 3.2.1. memory dump for fake fast memory areas broken | StingRay | support.WinUAE | 1 | 14 December 2015 20:39 |
Blizzard Turbo Memory - SMD memory chips doesn't work | sanjyuubi | Hardware mods | 5 | 26 May 2010 15:40 |
[68000 ASM] Move memory to memory | AmigaBoy | Coders. General | 7 | 08 December 2009 08:16 |
DMA memory to memory copy | BlueAchenar | Coders. General | 14 | 22 January 2009 23:29 |
|
|