Indvidision and monitor at odds with each other.

Hi,

Connecting the following:

A600 with Indivision ECS Scandoubler to a HP Monitor (HP L1710).

It shows the insert disk screen at switch on but it is very random it doing so.

When it does not display the insert disk screen it displays "Input Signal Out Of Range Change Settings To 1280x1024-60hz"

Indvision Scandoubler seems to max at 1024x768

HP Monitor does have 1024x768resolution

Suggestions to a remedy please

Best Regards

[pandy71]

Originally Posted by Cara

Suggestions to a remedy please

Resolution is just acronym for: "provide signal with particular H and V frequency" - in your case probably issue is related to V frequency (i assume 50Hz where HP expect to have 60Hz - this is common even for digital (DVI) signals fully valid from DVI/HDMI perspective but not 60Hz).

Not sure that Indivision can be forced to:
60Hz (possibility of major stutter for 50Hz)
75Hz (stutter less visible however present)
Ideally 100Hz but this can be not supported by display.