Flicker fixer and scan doubler, CyberVision 64/3D

[A3000T]

A3000t Idaho U.S.A.
I bought my A3000T back in the early 90's and CyberStorm MKII also the CyberVision 64/3D. I never was able to get the CV to work properly. I recently got my Amigas out of storage and got them working. I have A3000D, A3000T, A1200. I removed the batteries and cleaned the battery damage they all booted up. The A3000D had problems with the scan Doubler / Flicker Fixer. I found 7-11 traces that were open and jumper them out and after a few hours the A3000D was working. I used a O-Scope to verify I was getting the VC1 signal. I then used a ohm meter to find the open traces.
Next task was to get the CV 64 to work. I installed the CV64 software V4.1 I had the same problem as I did back in the 90's. I removed the CV software and installed Picasso96 and gtlayout.lha and identify.lha now the CV works GREAT! If you have issues with CV use Picasso96 or current software.
I thought problem might have been the CV board. The CV has 256megs of ram on it I wish some of it would be available for fast ram.
The only problem is finding a monitor that can handle all the modes. One way is to have two monitors or use a vga switch which I had but got rid months ago. I will keep looking for a good multi sync monitor under $30.00) and a vga switch ($5.00) at thrift stores. I bought the CV 64/3d when I bought my 3000T but was unable to get it to work back then. It works now! See post on forum.icomp.de by A3000T.