|
04 November 2011, 23:39
|
#1 |
|
Moderator
Join Date: Nov 2004
Location: Eksjö / Sweden
Posts: 5,602
|
A1200 dark brown SMD *ceramic* caps
I'm primarily looking for the value of the dark brown ceramic ones used with 10 Ohm resistors.
Is it known? Or do I just pick any ceramic "nF" one? Threads on eab seem electrolytically prejudiced... The reason I'm replacing this one is it's been beaten black and blue by an SMD electrolytic spasmodic one... Specifically, it's C302 by the keyboard connector. Wouldn't mind knowing the value of the light brown ones too 
|
|
|
05 November 2011, 07:57
|
#2 |
|
Precious & fragile things
Join Date: Feb 2009
Location: Victoria, Australia
Posts: 1,946
|
C302 is listed as 0.22uF or 220nF Photon, from Audio decoupling circuit.
SMT caps can have huge variances in spec even if they are the same size and also tolerances from Y5V to NPO and alike. |
|
|
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | |
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Lookie lookie – An (almost) all-ceramic capacitor A1200 | amigasith | support.Hardware | 46 | 05 February 2016 01:08 |
| Dave Haynie and SMD caps | matthey | support.Hardware | 37 | 24 April 2011 10:17 |
| Need SMD resistor values (A1200 1D1) | 8bitbubsy | support.Hardware | 1 | 13 December 2010 08:35 |
| 3-Pin Ceramic Resonator Question. | Charlie | support.Hardware | 2 | 30 April 2010 15:26 |
| Help indentifying SMD caps | 8bitbubsy | support.Hardware | 6 | 19 November 2009 00:27 |
|
|
