|
23 February 2018, 19:01
|
#1 |
|
Registered User
Join Date: Jan 2017
Location: London, UK
Posts: 433
|
3.6.0 Debugging Mode
Hi All,
I'm probably doing something wrong but when I enter the debugging Console (Shift-F12), it execute command e to see the chip registers, and I notice that BLPCON0 is not reflecting the state of the display, it show a value of 0x200... But since the display was hires bit 15 should have been set... Also, is there any way to see the content of the CIA port registers? |
|
|
23 February 2018, 19:30
|
#2 |
|
WinUAE developer
Join Date: Aug 2001
Location: Hämeenlinna/Finland
Age: 49
Posts: 26,502
|
Copper list probably sets it to 0x0200 when outside of display area. (Use o1 to check it, use od to enable collection of copper cycle info for more detailed information)
c shows most CIA registers. |
|
|
|
23 February 2018, 19:52
|
#3 | ||
|
Registered User
Join Date: Jan 2017
Location: London, UK
Posts: 433
|
Quote:
Quote:
|
||
|
|
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | |
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Debugging strategies | pipper | Coders. C/C++ | 43 | 17 June 2018 20:02 |
| Debugging? | MartinW | Coders. C/C++ | 10 | 03 January 2018 20:59 |
| Source Debugging + Linker? | wk_end | Coders. Asm / Hardware | 3 | 21 April 2016 13:40 |
| Remote C/C++ debugging? | alkis | Coders. C/C++ | 1 | 03 January 2014 12:17 |
| 'Warp Mode' broken in 'windowed mode' | NoX1911 | support.WinUAE | 3 | 26 May 2007 01:05 |
|
|
