Digi-View 4.0 and WinUAE in lo-res interlace problem?

[ImmortalA1000]

I was going to try running the Digi-View software for converting some images to the best possible output on Amiga but when I select interlace on the screen size menu the mouse cursor goes berzerk as if you have a 20,000DPI mouse connected.

Is this a known issue? Only affects interlace mode, if you don't put interlace mode on then it acts as normal.

Any fixes?

(tried OCS A500 KS1.3, ECS A500+ KS2.0 and even AGA A1200 configs...same thing)

[Toni Wilen]

Do you have any extra mouse options enabled? ("magic mouse" etc.. in gameports panel)

Could you boot using basic A500 or A1200 setup (no harddrives or any other expansions), create a statefile and attach it here for testing.

[ImmortalA1000]

I was using a standard A500, A500+ and A1200 basic configuration from the quickstart option Toni.

I've not enabled anything special to what I usually use. I will check back after looking up the statefile creation and attach once done no problem.

It was Digi-View 4.0 v 4.02 PAL software I believe (I will check this as well and try older versions too)

[Morbane]

boosting all of the memory options can help - but I have been able to do that because I have been using Amiga Forever.

[Toni Wilen]

I run DV 4.02, clicked interlace and then ok. Nothing strange happened. (A500 and A500+ quickstart)

Mouse behavior you described usually happens when using any kind of remote connection or virtual machine. These kinds of environments require "virtual mouse driver" option.