22 September 2019, 08:24 | #1 |
Registered User
Join Date: Sep 2019
Location: Essen/Germany
Age: 55
Posts: 463
|
Load config from commandline
Is it possible to run WinUAE from commandline with a Kickstart loading from disk?
When I configure it, I must put Kickstart in DF0 and obviously after that I have to put the Workbench disk also in DF0. So when I run the configuration it only boots up to the kickstart. When I put the Workbench directly in DF0 then the default ROM is provided, right? Last edited by sparhawk; 22 September 2019 at 08:32. |
22 September 2019, 09:23 | #2 |
WinUAE developer
Join Date: Aug 2001
Location: Hämeenlinna/Finland
Age: 49
Posts: 26,502
|
I don't understand your question. There is no "default" ROM that depends on DF0: contents.
|
22 September 2019, 09:52 | #3 |
Registered User
Join Date: Sep 2019
Location: Essen/Germany
Age: 55
Posts: 463
|
Sorry! I was confused, because I have an Amiga 1000 and from this I am used to first load the Kickstart from DF0. In WinUAE this is not necessary as you configure the rom in the settings and don't load it from disk.
|
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
Thread Tools | |
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Config - Load From... | AnnaWu | support.WinUAE | 2 | 24 October 2015 11:47 |
Load last config | mritter0 | support.WinUAE | 1 | 24 November 2014 11:09 |
Auto load config | DaveMB | support.WinUAE | 2 | 15 October 2010 19:32 |
Possible to start video recording from commandline/config | bLAZER | support.WinUAE | 2 | 01 March 2010 23:05 |
how to automatically load config | moriez | support.WinUAE | 3 | 22 February 2009 21:27 |
|
|