Indivision ECS on B2000-CR Rev 4.3 ?

I'm interested in installing an Indivision ECS in my Amiga 2000 (B2000-CR Rev 4.3), but unfortunately this is one of the board revisions which has a cap right next to the Denise chip. If I replace the cap with one of these (http://www.ebay.com/itm/10pcs-47uF-1...-/252680509456), will it be low enough in terms of height ? Or am I still going to run into clearance problems ?

Photo showing the problem is at http://eab.abime.net/attachment.php?...1&d=1492560091.

Thanks in Advance, Patrick

[Jope]

Just desolder the old one and mount it behind a couple of wires. This is what I did when I installed a VXL*30 into my A500+ as a kid. :-D

Originally Posted by Jope

Just desolder the old one and mount it behind a couple of wires. This is what I did when I installed a VXL*30 into my A500+ as a kid. :-D

@Jope

I like the suggestion! Attached is a picture of my mod

I don't have the Indivision, but have checked that I'm still getting video out following this

Thanks again,

Patrick

P.S. I'm new to this forum - how do I reference another member, like "@Jope" correctly!

[Jope]

Haha, excellent. :-)

There's no mention feature here, the way you quoted is the correct way.