strange problem with CWB 3.9

cugar124 · 11 March 2016, 10:53

Hi guys right I have the strangest of problems:

I install CWB 3.9 on my A1200 no problem works perfect!

Put it on my A3000 or A4000 and it just guru's on boot.

Specs are

A3000
A3640
20mb ram
budda
Piccolo
8 up memory
4gig cf card IDE on budda
Bluster 9

A4000
GVP Trex 8mb ram
10mb ram on mother board
256mb on bigram plus
tandem IDE
IDE CF card via onboard IDE
blust 11

fgh · 11 March 2016, 12:41

Is this a Boing Bag 2 install, and it works until setpatch reboots the system, then hangs?
(To check: After COLD boot, early startup menu is available, and booting without startup-sequence works)

In this case I suspect those two CF cards are LBA48 capable and trigger a bug in scsi.device 43.43 from BB2. Fix is to use v43.45 or similar. (See CF/SD & large drive FAQ)

Edit: Or are you perhaps loading some a1200 scsi.device?

11 March 2016, 10:53	#1
cugar124 Registered User Join Date: Jun 2012 Location: Belfast Posts: 82	strange problem with CWB 3.9 Hi guys right I have the strangest of problems: I install CWB 3.9 on my A1200 no problem works perfect! Put it on my A3000 or A4000 and it just guru's on boot. Specs are A3000 A3640 20mb ram budda Piccolo 8 up memory 4gig cf card IDE on budda Bluster 9 A4000 GVP Trex 8mb ram 10mb ram on mother board 256mb on bigram plus tandem IDE IDE CF card via onboard IDE blust 11

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Very strange problem	Arnie	support.WinUAE	5	26 February 2015 20:55
Problem installing CWB	videofx	project.ClassicWB	1	18 March 2013 21:55
CWB ADV WarpOS instalation problem	kwaku85	project.ClassicWB	1	27 September 2012 21:29
Strange problem	ami_junkie	support.Hardware	0	30 April 2010 13:06
Strange problem with Imagine 4 FP	Hell	support.WinUAE	6	16 March 2003 12:01

11 March 2016, 12:41	#2
fgh Registered User Join Date: Dec 2010 Location: Norway Posts: 817	Is this a Boing Bag 2 install, and it works until setpatch reboots the system, then hangs? (To check: After COLD boot, early startup menu is available, and booting without startup-sequence works) In this case I suspect those two CF cards are LBA48 capable and trigger a bug in scsi.device 43.43 from BB2. Fix is to use v43.45 or similar. (See CF/SD & large drive FAQ) Edit: Or are you perhaps loading some a1200 scsi.device?

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)