|
26 April 2008, 22:48
|
#1 |
|
Registered User
Join Date: Apr 2008
Location: Arlington, MA
Posts: 37
|
Transferred Hardfile comes up as NDOS in WinUAE?
I used Amiga Explorer to pull over the four partitions of the HDD on my A3000. Each partition took about three hours to transfer, but AE did not report any errors. On the A3000 itself, the machine boots off DH0: and DH1-3 all show up fine and SysInfo shows all four partitions are FFS.
But when I tried to run WinUAE (1.4.6) off those hardfiles, they all came up in WinUAE as not DOS disks. What's up with that? Data corruption during the transfer that AE didn't detect/report? ------- UPDATE: Never mind. After some googling, I found that I needed to get the drive geometry info from the Amiga and enter it into the WinUAE config. Last edited by rlcarr; 27 April 2008 at 03:27. Reason: Because I'm lame... |
|
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | |
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| WinUAE fails to access empty hardfile on IDE0 | thomas | support.WinUAE | 8 | 14 April 2012 21:26 |
| WinUAE hardfile corrupt "not a DOS medium" | oRBIT | support.WinUAE | 32 | 24 March 2012 08:36 |
| Amiga explorer hardfile to winuae | Fabie | support.Hardware | 8 | 07 January 2010 14:59 |
| Winuae Hardfile | littleb2005 | support.WinUAE | 3 | 03 May 2007 20:05 |
| Problem with hardfile under winuae a500 emulation | _ThEcRoW | support.WinUAE | 15 | 21 December 2005 19:37 |
|
|
